22-5. 3D Relative Cylindrical Polar Coordinates
Three-dimensional infinite as well as 3D Relative Cylindrical Polar Coordinates inwards AutoCAD
Command is entered on the cast @distance<angle,Z afterwards the ascendancy line of piece of job yous desire to draw.
Note that these coordinates are like alongside the Absolute deviation to us inwards this illustration the starting betoken CURRENT.
Given that hither nosotros create non get got X as well as Y coordinates, nosotros get got a touchstone starting direction EAST as well as therefore nosotros get got attention of it when working alongside these coordinates. (See Coordinate System)
Look at the motion-picture present above. To describe a starting betoken of a line of piece of job inwards 3D infinite using Cylindrical Polar Coordinates Relative it is necessary to specify the ascendancy every 2d follows.
- - Click on the Isometric push to switch to 3D thought (toolbar View)
- - To gear upwards the betoken T1 is needed: a click of a push LINE (starting betoken T1 lines)
- - Type @8.5<30,5 fourth dimension betoken T1 positioned inwards 3D infinite past times elements of orders that nosotros get got set. So 8.5 is our distance from the starting betoken (in this case, the electrical flow betoken where nosotros are as well as this is a T1), the angle at which nosotros left - the management is thirty degrees as well as the acme Z is v units.
What did nosotros do?
We were inwards T1. Using Cylindrical Polar Coordinates are defined Relative to our distance from T1 to survive 8.5 units of angle thirty ° as well as acme (Z) v units.
So the sequence of commands every 2d follows:
Command: _line [LINE push click to describe lines, depository fiscal establishment annotation that nosotros are inwards T1]
Specify kickoff point: @8.5<30,5 [setting upwards the kickoff betoken T1 - distance = 8.5 angle = thirty ° as well as acme (Z) = 5]
We were inwards T1. Using Cylindrical Polar Coordinates are defined Relative to our distance from T1 to survive 8.5 units of angle thirty ° as well as acme (Z) v units.
So the sequence of commands every 2d follows:
Command: _line [LINE push click to describe lines, depository fiscal establishment annotation that nosotros are inwards T1]
Specify kickoff point: @8.5<30,5 [setting upwards the kickoff betoken T1 - distance = 8.5 angle = thirty ° as well as acme (Z) = 5]