17-10. Autocad Chamfer Cutting Superlative Corner
How to cutting off the exceed of the corner inward AutoCAD amongst the ascendency CHAMFER?
CHAMFER command runs amongst toolbars MODIFY or from File Menu Modify => Chamfer, or the ascendency trouble prompt, type the command.
Order CHAMFER tin combine ii trouble (angle)
The cutting border of the linked lines is performed every bit follows:
EXAMPLE 1
Cutting off the exceed of the angle amongst the mouse.
TASK: Cut the tip of the correct angle for ten units, which brand upwardly ii lines- - click on the Chamfer
- - Contact the clause inward the ascendency trouble prompt. Choose i of them (in this example I chose Distance)
- - come inward the value of the laid out distance 10
- - Enter a value other distance 10
- - guide laid out object (line)
- - guide approximately other object (line)
- - press the ESC key
Command: _chamfer
(TRIM mode) Current chamfer Dist1 = 0.0000, = 0.0000 Dist2
Select laid out trouble or [Undo/Polyline/Distance/Angle/Trim/Method/Multiple]: D [type the missive of the alphabet D (d)]
Specify laid out chamfer distance <0.0000>: ten [type publish ten for the laid out line]
Specify minute chamfer distance <10.0000>: ten [type publish ten for the minute line]
Select laid out trouble or [Undo/Polyline/Distance/Angle/Trim/Method/Multiple]: [click on the laid out line]
Select minute trouble or shift-select to apply corner: [click on the minute line]
Described inward a higher house looks similar every bit shown below.
Cut the correct angle of the ii connected lines together with thence that trouble 1 connects trouble 2 at a twenty score angle
Command: _chamfer [start order]
(TRIM mode) Current chamfer Dist1 = 0.0000, = 0.0000 Dist2
Select laid out trouble or [Undo/Polyline/Distance/Angle/Trim/Method/Multiple]: Influenza A virus subtype H5N1 [selection clause Angle - an angle]
Specify chamfer length on the laid out trouble <0.0000>: xv [length of trouble that subtracts 1]
Specify chamfer angle from the laid out trouble <0>: twenty [angle that volition hold out connected to Line 1 Line 2]
Select laid out trouble or [Undo/Polyline/Distance/Angle/Trim/Method/Multiple]: [click on the trouble 1 - select]
Select minute trouble or shift-select to apply corner: [click on the trouble 2 - Select]
Command: chamfer (TRIM mode) Current chamfer Length = 15.0000, Angle = twenty [press ENTER]
Other subcommand explore yourself ;-)