21-3. Autocad Modeling Box 3D Draw
How to Draw Cube inwards AutoCAD - 3D model?
BOX command on the MODELING toolbar is used to depict 3D models such equally Cubes. (Example: when you lot depict a box amongst her side, combination Box as well as Shell commands)
Command tin live on run inwards ascendancy work prompt => BOX
Pay attending to the clause of this BOX command.
Also banker's complaint that hither nosotros function amongst 3 dimensions (length, width as well as height)
Command: _box
Specify kickoff corner or [Center]: * Cancel *
Command: * Cancel *
Command: _box
Specify kickoff corner or [Center]:
Specify other corner or [Cube / Length]: C
Specify length <124.6657>: Enter
Command: _box
Specify kickoff corner or [Center]:
Specify other corner or [Cube / Length]: L
Specify length <124.5392>: Enter
Specify width <117.9951>: Enter
Specify acme or [2Point] <124.5392>:
Command: _box
Specify kickoff corner or [Center]: C [note that this is the pump of a cube or rectangular 3D model as well as thus does non 2D figure.]
Specify center:
Specify corner or [Cube / Length]:
Specify acme or [2Point] <124.5392>: Enter
Command: * Cancel *
Command: _box
Specify kickoff corner or [Center]: C [note that this is the pump of a cube or rectangular 3D model as well as thus does non 2D figure.]
Specify center:
Specify corner or [Cube / Length]: L
Specify length <101.2323>: 100 + Enter
Specify width <87.0916>: 200 + Enter
Specify acme or [2Point] <124.5392>: 100
Command tin live on run inwards ascendancy work prompt => BOX
Pay attending to the clause of this BOX command.
Also banker's complaint that hither nosotros function amongst 3 dimensions (length, width as well as height)
Command: _box
Specify kickoff corner or [Center]: * Cancel *
Command: * Cancel *
Command: _box
Specify kickoff corner or [Center]:
Specify other corner or [Cube / Length]: C
Specify length <124.6657>: Enter
Command: _box
Specify kickoff corner or [Center]:
Specify other corner or [Cube / Length]: L
Specify length <124.5392>: Enter
Specify width <117.9951>: Enter
Specify acme or [2Point] <124.5392>:
Command: _box
Specify kickoff corner or [Center]: C [note that this is the pump of a cube or rectangular 3D model as well as thus does non 2D figure.]
Specify center:
Specify corner or [Cube / Length]:
Specify acme or [2Point] <124.5392>: Enter
Command: * Cancel *
Command: _box
Specify kickoff corner or [Center]: C [note that this is the pump of a cube or rectangular 3D model as well as thus does non 2D figure.]
Specify center:
Specify corner or [Cube / Length]: L
Specify length <101.2323>: 100 + Enter
Specify width <87.0916>: 200 + Enter
Specify acme or [2Point] <124.5392>: 100
If you lot depict inwards the 3D persuasion as: SE Isometric drawing when you lot tin as well as so meet how it volition expect similar your drawing (as you lot tin inwards 3 mouse clicks) or via the ascendancy amongst the entry of dimensions.
